SusProg3D - Suspension by Design.
===================
Version 4.87 adds additional functionality and a few bug fixes.
Thanks to all of those who made comments and suggestions.
In no particular order.
 | Added a stand alone spring calculator. Available in the Tools menu. Handy for those times when you have a spring and just need to know the rate. |
| If the Antirollbar Correlation Factor was zero, this caused the
antirollbar calculations to fail. It now defaults to 1.0 Thanks to Gavin for this one. |
| Added an option to the wheel alignment settings to allow for specifying
the toe in degrees. Typically, laser toe gauges have a resolution of 1/60th
of a degree, approx 0.02 degrees.
|
| Updated the registration algorithm for Vista.
|
| Added "double ball joints" to the CMM tool for struts. Thanks to Mark for this one. |
| Added the upright coordinates referenced back to the chassis datum. This
is makes it easier to position suspension component in the correct place
when the chassis is in the chassis jig. Thanks to Tim for this one. |
V4.87C adds the following
| V4.87A updated the registration methods to better handle both Vista and
laptops in general. Unfortunately this caused some registered installations to revert to evaluation and corrupt the licence file. This fixes the problem with the licence file, but will require a fresh user code. |
V4.87D adds the following
| Fixed a bug that prevented changing wheel and tyre sizes when using
Imperial units. Thanks to Petteri for this one. |